Tech Tips

Daylight Savings Time

None of our cameras automatically change date and/or time. If you want to change the date and/or time, you must do so on purpose. There is no auto adjusting for daylight savings time.

Food Plots and Time-Lapse

Use the Time-Lapse feature of your camera to monitor your food plots in the morning and evening hours. Set time-lapse interval to 1 or 5 minutes depending upon how many pictures you want during the morning and evening hours. This will be in addition to motion events that occur within range of the camera. We'd recommend you leave the motion events set to default settings (Trail). Follow this link to see how Wildlife Research Biologist Dr. Grant Woods uses Time Lapse to monitor Food Plots at GrowingDeer.tv

General Tips

Mounting your RapidFire camera

Your camera comes with an adjustable bungee cord that can be used to mount the camera to any size tree. Given the stretch of the bungee cord, you can always wedge a stick behind the camera to get the appropriate tilt for any situation. To secure the camera use a Python lock by MasterLock. The camera is designed specifically so that you can secure it snugly to a tree using a Python lock. If you need more flexibility in aiming, you can always use the RECONYX VersaMount to fasten the camera to a tree or other solid structure. It allows you infinite flexibility in aiming the camera.

Normally, we recommend you mount the camera at about chest height - where it is easy to access the card, batteries, and controls. If, however, you are concerned about the slight red glow of the illuminator spooking animals, you can mount the camera a bit higher and aim it downward. Most animals do not often look up and therefore are less likely to notice the camera if it is mounted a few feet higher. If you do this be sure to use the Walktest mode (see below) to be sure the aim is correct.

Walktest Mode

Learning to use the Walktest mode is critical to be as successful as possible with your RECONYX camera. The Walktest mode allows you to precisely determine your camera's active motion detection zones - insuring your camera is aimed exactly where you want to capture animal activity.

All RECONYX cameras will self-arm from Walktest mode after a two minute period during which they do not detect motion. This makes the Walktest mode very easy to use. You can put the camera in Walktest mode, secure the cover and lock it to the tree and still make minor tweaks in the aim of the camera. When you are confident the camera is aimed properly, just walk away. It will arm itself 2 minutes later.

Monitoring a Trail

Place your camera perpendicular to the trail. With our InstaOn and RapidFire technologies, you can finally monitor a trail with a true "trail" camera. By placing the camera off to the side, you minimize the likelihood the deer will see the camera and change their behavior because of it. Again, use the Walktest mode to make sure the camera is aimed properly.

Consistent Night Time Performance

If you find your night time pictures dim over the life of the batteries, this is more than likely because you are running Alkaline batteries, which are not designed for high power devices like Reconyx infrared cameras. The illuminator in Reconyx cameras require high output batteries, and Alkaline batteries are not ideal for this. If you want a consistent illumination range over the life of your batteries, you should switch to NiMH rechargeable batteries or AA lithium batteries; we offer both types; just  click "Shop" if you'd like to improve your night time performance (and save money over time).

Check back often for additional Tech Tips.

 

Please contact us at support@reconyx.com with any questions or issues.